Apollo XP95 Switch Monitor
Summary
The XP95 Switch Monitor with Isolator is designed to monitor the state of one or more single pole, volt-free contacts connected on a single pair of cables and to report the status to Apollo compatible control equipment. The Switch Monitor has four input states, ‘normal’, ‘fault’, ‘pre-alarm’, and ‘alarm’. The product has two visable LED’s and is Loop Powered.
Key Features
The Switch Monitor provides four input states to the control equipment: “Normal” “Fault” “Pre-alarm”and “Alarm”. These are derived from the switched resistive values. The Switch Monitor has a red LED to indicate an alarm and two yellow LEDs to indicate a switch input wiring fault or a loop short-circuit wiring fault. The Switch Monitor is fitted with a bi-directional short- circuit isolator and will be unaffected by a single short- circuit on either loop input or output.
Specifications
- Loop Operating Voltage : 17V DC
- Maximum Loop Operating Voltage : 28V DC
Maximum Current Consumption @ 24V
- Switch On Surge, Max 150ms : 3.5mA
- Quiescent, 20ohms EOL Fitted : 1.25mA
- LED Off, Switch Input Closed : 1.5mA
- LED On, Switch Input Closed : 3.5mA
- LED On, Switch Input S/C : 3.6mA
- Maximum Continuous Current : 1A
- Maximum Switch Current : 3A
- On Resistance : 0.2ohms
- Switch Input Monitoring Voltage : 9-11V DC
- Maximum Cable Resistance : 50ohms
- Operating Tempurature : -20 to +70 Degrees Celcius
- IP Rating : 54
Downloads
- Datasheet (Adobe PDF)
Additional information
| Weight | 0.2 kg |
|---|