IP65 Weatherproof 24V Power Supply
£50.53 – £86.64
Summary
The increasing demand for security and monitoring equipment to be used in external locations has meant installers and specifiers need to consider how best to power these devices locally and safely.
Dycon has created a new IP65 climate-resistant housing system that can be used with the majority of its switched-mode power supply modules with or without battery back- up. The housing is thermo-resistant ABS and impact resistant to IK07/8, making it suitable for use in most external locations, it is also ideal for use in loft/roof spaces, garages, and warehouses.
Dycon’s unique 2 mm steel backplate has been ready prepared to accept the majority of its power supply modules so that you can now choose the correct power system for the job rather than have to compromise to get moisture and temperature protection.
Innovative rear fixings brackets allow for either vertical or horizontal mounting and remove the need to drill holes into the housing thus compromising its integrity. Alternatively, the housing can be fixed from the inside, this requires drilling through the marked locations with a 20 mm drill (not supplied). 2x 20 mm glands are supplied which can be fitted on any side. Location in direct sunlight should be avoided with battery backed- up units. Battery charging models are supplied with a water-proof pressure valve to safely vent any gases created during charging.
Key Features
- Battery charging – 24VDC models are available with or without battery charging capability.
- Indicators – ss standard, the housing has no indicators visible from the outside to avoid drawing attention to it. An AC ‘Main OK’ indicator is available which maintains the IP65 rating. This is located on the side of the unit.
- Fault outputs – a range of PSU’s with fault outputs is available. These show ‘Mains OFF’, ‘Battery Fault ‘, and ‘PSU Fault’ and can be used for optional indicators or connected to other equipment to remotely signal the fault conditions.
- Fixings – two powder-coated steel brackets with stainless steel screws to avoid drilling through the housing are included. These can be fitted on the sides or on the top and bottom. The brackets are reversible allowing the use of the eyelet at the top and a slot to be used at the bottom. These brackets allow for easy adjustment when fitting. Alternatively, the 4 allocated fixing positions can be drilled through from the inside of the box.
- Fixing plate – a removable zinc plated 2 mm steel plate is supplied and comes with fixings for various Dycon 12VDC, 24VDC, and 24VAC power supplies, with or without battery charging and fault outputs.
- Battery – the housing has space for 2 x 2.1A Ampere 12VDC VRLA batteries in addition to the power supply.
- Safety valve – units with battery charging are fitted with a unique automatic pressure valve that maintains the weatherproofing but regulates the pressure required for VRLA battery charging applications.
- Glands – 2 x 20 mm glands are included which can be fitted where required on the sides, bottom or top. These glands require a 20 mm hole to be drilled in the preferred position.
Specifications
- Material : Thermo-resistant ABS
- Construction : Double insulation, smooth walls
- Material Sealing Class : EPDM
- Protection : IP65 according to EN60529
- Glow Wire Test : 650 ÃÅ C
- Impact Resistance : IK07, IK08
- Dimensions (L x W x H) : 240 x 190 x 90mm
- Colour : Light grey RAL7035
- Fixing Bracket : 2 x fixing bracket external powder coated 2mm steel
- Lid : Fixed with 4 front screws
- Weight : 1.45kg
Downloads
- Datasheet (Adobe PDF)
Additional information
Weight | 1.45 kg |
---|---|
Amp | 1A, 2A, 3A |
Battery Charging | No, Yes |
Fault Relay/LED | Relay Only, None, Both |